Publish Time: 2022-08-16 Origin: Site
As the awareness of fitness increases, swimming pool heat pumps are becoming popular. Let's take a look at the installation methods and precautions for the swimming pool heat pump.
Here is the content list:
Swimming pool heat pump installation method
Swimming pool heat pump installation precautions
First of all, it is very important to choose the location of the pool air unit installation, which must be well ventilated and more than 1 meter away from the building, and there must be no debris around to prevent adsorption on the evaporator. When multiple units are installed side by side, the evaporator spacing is more than 1 meter. The closer the swimming pool heat pump is to the pool, the better, generally keep it within 8 meters and do a good job of pipe insulation.
1) Combined with the swimming pool water treatment pipeline, plus a tee connected to its pipeline above, behind the pipeline tee should be installed with an electric control valve. The advantage of this swimming pool heat pump installation method is: that whether the pool heat pump unit is working or not, it does not affect the resistance of the water cycle.
2) Series connection to the swimming pool water circulation pipeline above, in the original pool water circulation pipeline directly adds several swimming pool heat pump units, without the need to draw an additional pipeline. The advantage of this approach is the direct use of water treatment pipeline circulation, without the need to increase the circulation pump.
With the above two installation methods, no matter which installation method is used, the accessories that should be installed are
1) Should be given to the swimming pool special swimming pool heat pump thermostatic unit installed with a soft connection to avoid pipeline vibration.
2) A filter should be installed on each unit to prevent impurities from entering the equipment and to protect the swimming pool heat pump service life.
3) The units must be installed in parallel with each other to avoid the uneven water flow of each unit, which will shorten the life of the swimming pool heat pump.
1, Swimming pool heat pump should be installed with the same program piping layout to avoid insufficient water inlet for each unit. The water flow of each unit in the same program pipeline is the same, so the heat production is a more uniform and almost synchronous start and stop. There will not be a large difference in the working hours of swimming pool air units.
2, Swimming pool heat pump unit should be selected and installed according to the situation of the installation site. The installation site is generally chosen on the roof of the building or in a place with good outdoor air circulation. Avoid installing the unit in the basement as much as possible, because poor air circulation in the basement and outdoors will cause low energy efficiency and no heating of the unit.
3, Swimming pool heat pump piping installation should be well insulated, one to avoid heat loss in winter, and the second to prevent freezing. It is recommended that all hot water pipes of swimming pools in northern areas should be insulated.
4, Before the installation of the unit should do a good job of equipment foundation, the equipment foundation of the concrete type: plain concrete strip foundation, concrete strength grade: C25, width 150-300mm, height 0.3m.
5, Swimming pool heat pump unit should do a good job of condensate drainage tank or drainage pipe of the unit, the general standard pool uses more than ten units, the condensate in summer and the frost water in winter need to flow into the drainage pipe or drainage tank.
The above is the related content about the installation method and precautions for swimming pool heat pump, if you are interested in a swimming pool heat pump, you can contact us, our website is https://www.laileyheatpump.com/.